Complete driveshaft Lancia Fulvia series 2-3 all models

Supplied with wheel side nut and gearbox side fixing screw set + stops.

These drive shafts are identical to the original, except for the wheel-side boot. The original boot tends to fold inwards and is thus worn by the CV joint tripod. A tear can then quickly occur. With our modification, this boot tearing problem is eliminated.

For gearboxes with small output flanges on the drive shaft side (99% of Fulvia series 2)

Ø101mm flanges

NOTE: The 1600 HF models have drive shafts with large output gearbox flanges. Therefore, a large-diameter constant velocity joint (CVJ) Ref. TRA011 is required.